Handle heater 20W

Grip heater kit for snowmobiles, ATV's, dirtbikes and such. Contains 2 x 20W heater elements to be installed either on your old switch or the HIGH-OFF-LOW switch from our selection.

Buy resistors as well if required.

How to install:

1. During the installation, the temperature must be 15-20°C and air humidity must not exceed 60%.
2. Clean the handlebar with care.
3. Place the heaters on top of the handlebar ends. Make sure that the elements stick properly (especially from the edges).
4. The glue will dry in 12 hours.